[. . . ] SPECIFIED CONDITIONS OF USE The electronic drill/screwdriver can be universally used for drilling, percussion drilling, screwdriving and cutting screw threads. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. [. . . ] This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. The ventilation slots of the machine must be kept clear at all times. If the machine is mainly used for percussion drilling, regularly remove collected dust from the chuck. To remove the dust hold the machine with the chuck facing down vertically, and completely open and close the chuck. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. Read all safety warnings and all instructions, including those given in the accompanying brochure. [. . . ] When working in walls ceiling, or floor, take care to avoid electric cables and gas or waterpipes. NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]